Products

Stainless Steel Bands fabricated to provide fastening function, with full round edge on both sides. Stainless Steel Bands manufactured from SS 304, SS 304L, SS316 & SS 316L in a special soft annealed temper to facilitate handling. Stainless Steel Bands comes with a de-burred edge for personnel safety. It is available in a full range of widths, 13mm, 15mm, 20mm, 25mm, 40mm, 50mm and thickness range from 0.4mm up to 1.2mm in both 2B finish and Bright finish, other width less 400mm can be made to order. Stainless Steel Bands offers the greatest strength and corrosion resistance. The banding is typically packaged in 10~20 kg coils, shrink wrapped or paper wrapped, in pallets or crates for ocean shipping .

EXPANSION SPRING Type 304 stainless steel flat expansion springs used to secure insulation over small diameter insulated piping, tanks, vessels, and equipment subject to expansion and contraction. They can be used with any common width of strapping up to 3/4" APPLICATION EXPANSION SPRINGS / CHIL-SPRING are simply attached to strapping with stainless steel wing seals. The strapping is slipped through the seal and then through the spaced opening at either end of the EXPANSION SPRING / CHIL-SPRING. The strapping is then bent back and the wings of the seal are flattened. Strapping is then extended completely around the insulated object, or to the next spring, and the same routine is repeated until the entire circumference has been encircled. Maximum expansion of the 4" spring should not exceed 2-1/2" beyond its original length; it is recommended that each spring be stretched 1/2" upon installation. This allows an additional 2" expansion capability per spring. The number and size of CHIL-SPRING expansion springs to be used should have an expansion capability of at least twice that of the expected expansion of the object. Extreme care should be taken to assure that stresses are evenly distributed around the insulation

MPI Seals are easy to remove type Inspection plugs for use in insulation Piping & Equipments. These Inspection Plugs consists of an elastomer sleeve and a metal cap, with or without handle, lanyard and locking ring. No special tools, O-rings, transition gaskets, contoured flanges or “goof” required. Easy to remove & re use. Available in 2.5”, 3” and 5” (64, 76 and 127mm) sizes with or without handle, lanyard and locking ring.

Stainless Steel Tie wire is drawn to Precision diameter and then soft annealed for quick field insulation tie ups. Stainless Steel Tie Wire Available in Type 304,316,316L & Diameter of 0.5 to 2mm.

SS Compression Springs are assembled from components of Stainless steel Type 304. Compression springs are used with strapping to secure insulation over large diameter insulated piping, tanks, vessels, and equipment. APPLICATION Stainless Steel strapping 3/4" X .020" is slipped through and back over the slots on one end of the flat bottom of the spring. The strapping is secured with a 3/4” closed seal and is extended around the object, or to the next spring and the routine is repeated until the entire circumference has been encircled. To accommodate expected expansion of the object, the number of compression springs to be installed is based on a maximum compression of 1-1/2" per spring. Install one compression spring for every 25' of strapping. When tensioning the strapping, compress each unit a total of 1/2" extreme care should be taken to assure that spring compression and strapping Stresses are evenly distributed around the object.